Fbt DLM26 User Manual download pdf (Page 52)

To Edit press ENTER on the Name Page and the entering arrow will appear as in the example

below:

The first letter position will be blinking.

Select the Character position from the 6 available by rotating the “NAV/Param.1” encoder, then by

using the “Param.2” or 'Param.3” encoder it is possible to select the desired character.

Once you are happy with your name selection, press “ENTER” to confirm the edited Name. The

new name will be stored. The following example shows “Sub” replacing our previous name of

“Low”:

Source page – from this page it is possible to assign one of the following Inputs to any Output

Channel:

4. Input A

5. Input B

6. Sum of Input A/2 + Input B/2

The following is an example screen for the “Source” where Input A is assigned to Output

Channel 1:

After pressing ENTER an arrow will appear on the left of the screen “->” the Input can be selected

by rotating either the “Param.2” or “Param.3” encoders.

Out-1 Low Name

-> Name = Low

Out-1 Sub Name

Name = Sub

Out-1 Name Source

Source = InA

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 65 66

No comments

Fbt DLM26 User Manual Page 52